Shakey Jake Mouth Harp Blues Bluesville DG RVG NM 1961
$
28
$ 28
Sold For
Jul 11, 2010
Sold Date
Jul 4, 2010
Start Date
$ 10
Start price
7
Number Of Bids
USA
Country Of Seller
eBay
Auctioned at
Favourite Auctions
To save auctions to your favourites, please login
If you don't have an account, please register
Description
wrigley Store
Shakey Jake Mouth Harp Blues Bluesville DG RVG NM 1961
Search
SHAKEY JAKE MOUTH HARP BLUES LP ....ORIGINAL DEEP GROOVE LP.... ....RECORDING ENGINEER: RUDY VAN GELDER.... PERSONNEL:
- SHAKEY JAKE - VOCALS & HARMONICA
- JIMMIE LEE - GUITAR
- ROBERT BANKS - PIANO
- LEONARD GASKIN - BASS
- JUNIOR BLACKMON - DRUMS
- OUTER SLEEVE: VG/VG+ (light general ageing and edge-wear; 3/4 length split bottom seam....see photos)
- INNER SLEEVE: Anti-static replacement
- LP: NM (very nice; has some liner marks that do not affect play....see photos)
- LABEL: VG++/NM (light center-hole rubs....see photos)
RECORDS:
- Sealed: Store stock new
- Mint: Like new or near new with only one or two small insignificant defects
- Near Mint/M-: Extremely nice. Would be Mint, except for a possibly a couple of light hairlines or scuffs
- VG++: Still a very nice record with all or nearly all of its original gloss but may have a few more light, surface marks, hairlines, needle tracks or the like
- VG+: A nice, but used record that may have a series of light scuffs or scratches. It probably plays with a some pops
- VG: A well-used record that still should sound OK when played, but may have moderate surface noise, pops, and even a possible skip.
- VG-: A very well-worn record that plays through, probably has skipping and snap, crackle, pop
- Good: Probably will play through but with much in the way of surface noise, pops, crackles, skips etc.
- Fair: You’re getting this record just to own.
- Poor: The sky’s the limit as far as condition in the negative sense
- I will give greater weight to the condition of the front cover than back cover when assigning an overall grade
- Stickers – I will state if there are any
- If I write that a cover has a punch-hole, I’m talking about a small punch-press type hole
- A factory saw mark is a narrow cut in the perimeter of the cover, could be anywhere and vary in length from 1/2” to 2” at the most.
price rating
